Jandy VS PLUSHP 2.7 HP User Manual

Page 16
ENGLISH
Jandy
®
Variable-Speed Pumps
|
Installation & Operation Manual
* WARNING
ELECTRICAL SHOCK HAZARD
Due to the potential risk of fire, electric shock, or injuries to persons, Jandy
®
Pumps and any auxiliary loads must be installed
in accordance with the National Electrical Code
®
(NEC
®
), all local electrical and safety codes, and the Occupational Safety and
Health Act (OSHA). Copies of the NEC may be ordered from the National Protection Association, 1 Batterymarch Park, Quincy,
MA 02169, or from your local government inspection agency.
In Canada, Jandy Pumps must be installed in accordance with the Canadian Electrical Code (CEC).
* The Auxiliary Load relay contacts are rated at 230V/115V, 11A RMS. Please ensure the requirements of the equipment to be
connected to the Auxiliary Load do not exceed this rating.
** 115VAC power supply for main pump power is supported on DV2A models only.
Breaker Panel
Filter Pump Junction Box
Auxillary 1
RS485
Line (in)
Red
Black
Yellow
Green
Load (out)
1 2
Line (in)
Line 1
Load 1 Load 2
Load (out)
1 2
Auxillary 2
Line (in)
Load (out)
1 2
Line (in)
Load (out)
1 2
Auxillary Load
230VAC
External Enclosure
230/115VAC
Supply Power
(GFCI Breaker)
Breaker Panel
230VAC Supply Power
(GFCI Breaker)
Breaker Panel
230VAC Supply Power
(GFCI Breaker)
1 2 3 4
Dry Contacts
1 2 3 4
COM
L1 L2/N
Supply Power Input
Ground
Ground
Load 1 Load 2
Auxillary Load
230VAC
Ground
Dry Contact Speed Settings
Please refer to table 4 on the
following page for Dry Contact
Speed Settings.
DIP Switch
3 4
OFF OFF
Line 2/Neutral
Line 1
Line 1
Line 2
Line 2
Figure 12. 230V Auxiliary Relay Wiring Diagram*
Breaker Panel
Filter Pump Junction Box
Auxillary 1
RS485
Line (in)
Red
Black
Yellow
Green
Load (out)
1 2
Line (in)
Line 1
Load 1 Load 2
Load (out)
1 2
Auxillary 2
Line (in)
Load (out)
1 2
Line (in)
Load (out)
1 2
Auxillary Load
115VAC
External Enclosure
230/115VAC
Supply Power
(GFCI Breaker)
Breaker Panel
115VAC Supply Power
(GFCI Breaker)
Breaker Panel
115VAC Supply Power
(GFCI Breaker)
1 2 3 4
Dry Contacts
1 2 3 4
COM
L1 L2/N
Supply Power Input
Ground
Ground
Load 1 Load 2
Auxillary Load
115VAC
Ground
Dry Contact Speed Settings
Please refer to table 4 on the
following page for Dry Contact
Speed Settings.
DIP Switch
3 4
OFF OFF
Line 1
Line 1
Neutral
Neutral
Line 2/Neutral
Figure 13. 115V Auxiliary Relay Wiring Diagram*

Jandy VS PLUSHP 2.7 HP Specifications

General

Brand	Jandy
Model	VS PLUSHP 2.7 HP
Category	Water Pump
Language	English