janitza UMG 508 - Page 59

59
UMG 508
Voltage
Drop
A drop in voltage is set in % of the nominal vol-
tage.
Overvoltage
The overvoltage is set in % of the nominal vol-
tage.
Current
Overcurrent
The rapid increase of current is set in % of the
nominal current.
Accept L2-L4
Monitoring of events can be set per phase. You
can accept settings from phase L1 into phases
L2, L3 and L4.
• No- Settings from phase L1 are not taken
over into phases L2, L3 and L4.
• Yes- The settings from phase L1 are taken
over into phases L2, L3 and L4.
Follow-up time
The follow-up time can only be set with
GridVis.
Factory pre-setting: 0
C
Preparation time
The preparation time can only be set
with GridVis.
Factory pre-setting: 0
C