48
UMG 508
Communication
The UMG508 has an Ethernet and a RS485 in-
terface.
Ethernet (TCP/IP)
Select the type of address allocation for the
Ethernet interface here.
DHCP mode
• Off- IP address, Netmask and Gateway are
specified by the user and set directly on the
UMG508. Select this mode for simple net-
works without a DHCP server.
• BOOTP - BootP permits the fully automatic
integration of a UMG508 in an existing net-
work. BootP is an older protocol and does
not have DHCP's extent of functions.
• DHCP- Upon starting, the UMG508 automa-
tically collects the IP address, the Netmask
and the Gateway from a DHCP server.
Factory pre-setting:DHCP
The UMG508 may only be connected
to the Ethernet after coordinating with
the network administrator!
m
To Next Page
