Janome 5300QDC - LCD Display and Touch Panel

11
LCD Display
NOTE:
0DJQHWLFRUHOHFWURVWDWLFLQWHUIHUHQFHPD\FDXVHWKH
/&'GLVSOD\WRÁLFNHU
Do not use the machine near appliances that generate
DPDJQHWLFÀHOGRUDQHOHFWURVWDWLFÀHOGVXFKDV
microwave ovens.
The LCD display shows following information when the
machine is turned on.
q 6WLWFKSDWWHUQ
w0RGH
e 6WLWFKSDWWHUQQXPEHU
r ,GHQWLÀFDWLRQOHWWHURIWKHUHFRPPHQGHGIRRW
t 6WLWFKZLGWK
y6WLWFKOHQJWK
re
w
q t y
Touch Panel
q Mode key
When the power switch is turned on, the direct pattern
selection (mode 1) is set automatically.
Press the mode key to change the mode. Refer to
page 24.
w Clear key
Press the clear keyto cancel the input and select the
ÀUVWVWLWFKSDWWHUQRIWKHVHOHFWHGPRGH
,QSDWWHUQFRPELQDWLRQ
Press the clear key to clear the registered stitch
pattern.
Press and hold the clear key until the buzzer beeps to
clear whole pattern combination. Refer to page 70.
e Mirror image key
3UHVVWKHPLUURULPDJHNH\WRÁLSWKHVHOHFWHGVWLWFK
pattern vertically. Refer to page 63.
r Memory key
Press the memory key to register the selected pattern.
Refer to page 61.
t Number keys (Refer to page 24)
'LUHFWSDWWHUQVHOHFWLRQ
You can select the stitch patterns from 01 to 10
directly in mode 1 (direct pattern selection mode).
1XPHULFSDWWHUQVHOHFWLRQ
Enter a 2-digit pattern number to select the desired
stitch pattern in modes 2 to 5.
y Stitch width adjusting key
Press “+” or “–” to change the stitch width or needle
drop position, depending on the selected stitch
pattern. Refer topages 29, 32, 39 and 50.
u Stitch length adjusting key
Press “+” or “–” to change the stitch length of the
VHOHFWHGSDWWHUQ<RXFDQDOVRDGMXVWWKHEXWWRQKROH
density, the evenness of darning, and the size of
eyelet with this key. Refer to pages 29, 32, 39, 44 and
46.
i Cursor key
Press “
” or “ ” to move the cursor to check or edit
the pattern combination. Refer to pages 69 and 70.
qwer t
y
u
i