Janome 5300QDC - Winding the Bobbin

19
NOTE:
6HWWKHVSHHGFRQWUROVOLGHUDWLWVIDVWHVWSRVLWLRQIRU
bobbin winding.
Winding the bobbin
q
w
z
x c
v
b
n m
z Draw the thread from the spool and pass the thread
around the bobbin winding tension disk.
q Bobbin winding tension disk
x Thread through the hole in the bobbin from the inside
to the outside.
c Put the bobbin on the bobbin winder spindle.
v Push the bobbin to the right.
The bobbin icon appears on the LCD display.
w Bobbin icon
b With the free end of the thread held in your hand, start
WKHPDFKLQH6WRSWKHPDFKLQHZKHQLWKDVZRXQGD
few layers, and then cut the thread close to the hole in
the bobbin.
n 6WDUWWKHPDFKLQH:KHQWKHEREELQLVIXOO\ZRXQGLW
will stop spinning automatically.
  6WRSWKHPDFKLQHDQGUHWXUQWKHEREELQZLQGHUWRLWV
original position by moving the spindle to the left.
NOTE:

Do not move the bobbin winder spindle while the
machine is running.

Do not loosen the setscrew of bobbin winder stopper.
m Remove the bobbin. Cut the thread as shown.
Return the speed control slider position.