Janome 5300QDC - Changing the Needle

16
Changing the Needle
CAUTION:
Turn OFF the power switch before changing the
needle.
Raise the needle to its highest position by turning the
handwheel counterclockwise, and lower the presser
foot.
A loose needle or a loose screw may cause machine
malfunction or needle to break.
Loosen the needle clamp screw by turning it
counterclockwise with a screwdriver. Remove the needle
from the needle clamp.
,QVHUWDQHZQHHGOHLQWRWKHQHHGOHFODPSZLWKWKHÁDW
side to the rear. When inserting the needle into the
needle clamp, push it up as far as it will go.
7LJKWHQWKHQHHGOHFODPSVFUHZÀUPO\E\WXUQLQJLW
clockwise with a screwdriver.
q Needle clamp screw
w Flat side
7RVHHLIWKHQHHGOHLVLQJRRGFRQGLWLRQSODFHWKHÁDW
VLGHRIWKHQHHGOHRQWRVRPHWKLQJÁDWQHHGOHSODWHJODVV
HWF7KHJDSEHWZHHQWKHQHHGOHDQGWKHÁDWVXUIDFH
should be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
LQNQLWVÀQHVLONVDQGVLONOLNHIDEULFV
q
w