Janome 5300QDC - Eyelet

46
Adjusting the shape of an eyelet
Correct the shape of the eyelet as follows:
“L3” is the default setting value.
If the eyelet gap overlaps, press the “+” sign on the stitch
OHQJWKDGMXVWLQJNH\WRPDNHWKHGDUQHYHQ
If the eyelet gap opens, press the “–” sign on the stitch
OHQJWKDGMXVWLQJNH\WRPDNHWKHGDUQHYHQ
q6WLWFKOHQJWKDGMXVWLQJNH\
NOTE:
7KHVKDSHFDQEHDGMXVWHGZLWKLQ/WR/
Eyelet
q 6WLWFKSDWWHUQ 02'( 
w Thread tension dial: 1 to 4
e3UHVVHUIRRW 6DWLQVWLWFKIRRW)
The eyelet is used for belt holes etc.
Starting to sew
Lower the needle at the starting point and lower the
SUHVVHUIRRW6WDUWWKHPDFKLQH
The machine will stop automatically when completed.
q 6WDUWLQJSRLQW
Open the eyelet with an awl, eyelet punch or pointed
scissors (an awl, eyelet punch or pointed scissors are not
provided with the machine).
q
4
weq
+–
q