Janome 5300QDC - Inserting the Bobbin

20
Inserting the bobbin
CAUTION:
Turn OFF the power switch before inserting the bobbin
and threading the bobbin holder.
z Place a bobbin in the bobbin holder with the thread
running off counterclockwise as shown on the hook
cover plate.
q End of thread
w Bobbin holder
e Hook cover plate
x +ROGWKHEREELQZLWK\RXUÀQJHUWLSVRLWGRHVQRW
rotate.
  *XLGHWKHWKUHDGLQWRWKHIURQWQRWFKRIWKHEREELQ 
holder.
Pull the thread to the left to pass it under the guide.
r Front notch
t*XLGH
c Draw the thread to the left to pass it into the guide
path marked “1”.
  0DNHVXUHWKDWWKHWKUHDGFRPHVRXWIURPWKHVLGH 
notch of the bobbin holder.
y*XLGHSDWK
u6LGHQRWFK
NOTE:
If the thread does not come out from the side notch,
rethread from step z.
v Continue to draw the thread along the guide path
marked “2” and pull the thread to the right through the
slit. The thread will be cut to a proper length and held
in place.
i*XLGHSDWK
o6OLW7KUHDGFXWWHU
b 6HWWKHOHIWHGJHRIWKHKRRNFRYHUSODWHLQWRRSHQLQJ
3XVKGRZQWKHKRRNFRYHUSODWHWRÀWLQSODFH
!0 Hook cover plate
NOTE:
Unless otherwise noted, you can start sewing without
drawing up the bobbin thread.
Refer to page 23 for how to draw up the bobbin
thread.
z
x
c
v
b
t
y
u
i
o
!0
r
e
w
q
u