Janome 5300QDC - Machine Threading and Needle Threader

21
CAUTION:
Turn OFF the power switch before threading the
machine.
x
z
c
v b
z Turn the power switch off.
Draw the end of the thread around the upper thread
guide.
Threading the Machine
x While holding the thread near the spool w, draw
the end of the thread down around the check spring
holder e.
w6SRRO
e Check spring holder
c Firmly draw the thread up from right to left over the
take-up lever, and down into the eye of take-up lever.
r Eye of take-up lever
v b6OLGHWKHWKUHDGWRWKHOHIWWRSDVVWKURXJKWKHORZHU
WKUHDGJXLGH6OLGHWKHWKUHDGEHKLQGWKHQHHGOHEDU
thread guide from the right.
t Lower thread guide
y Needle bar thread guide
n Use the needle threader to thread the needle (see
page 22).
Raise the presser foot. Press the
needle up/down button q to raise
the thread take-up lever to its
highest position.
q Needle up/down button
e
r
t
y
q
w
w
z
c
v
b
n
x