Janome MC 11000 - Replacing Needle Threader Motor (1); Needle Threader Motor Removal

To remove:
1. Remove the face cover and the top cover.
2. Loosen the screw (A).
3. Disconnect the bobbin winding motor and the needle
threader sensor from printed circuit board U.
Note: Remove the cords from the cord guide (1).
4. Remove the 2 screws (B) and remove the motor.
Note: Remove the lamp supporter (2) before replacing the
motor.
(A)
(B)
Replacing Needle Threader Motor (1)
(1)
(2)
9
www.promelectroavtomat.ru