Janome MC 11000 - TTP Adjusting Mode; Touch Panel Adjustment

MC 11000
PRESS MARK
á@
4
2
5
ADJUSTMENT END
OK
1
3
TTP Adjusting Mode
If a different stitch appears on the touch panel from the one pressed when selecting a
desired stitch, follow the instructions below.
To adjust touch panel:
1. While pressing the Needle Up/Down button (1),turn
the power switch on. (Keep pressing the Needle Up/
Down button until “PRESS + MARK” and “+” appear.)
2. Press the “+” mark with astylus or the tip of the
additional spool pin.
(Press to in order.)
3. When you press the fifth “+”, “ADJUSTMENT END”
will appear on the touch panel.
4. Turn the power switch off. Turn the power switch
back on again and check the touch panel.
(1) Needle Up/Down button
(2) Power switch
(3) Touch panel
1
(1)
(2)
(3)
30
5
www.promelectroavtomat.ru