MC 11000
(A)
(A)
Replacing DC Motor and Adjusting Motor Belt Tension
Replacing DC Motor
To remove:
1. Remove the belt cover.
2. Remove the motor belt.
3. Disconnect the motor connector from printed circuit
board A.
4. Remove the 2 screws (A) and replace the motor.
To attach:
5. Follow the above procedure in reverse.
Adjusting motor belt tension
1. Tighten the 2 screws (A) slightly.
2. Adjust the slack in the motor belt to about 5.0 mm
(1) by pressing the middle of the motor belt in with
your finger with 200 grams of pressure (2).
3. Tighten the screws (A) securely.
4. Attach the belt cover.
(1)
(2)
16
5 mm
(Gauge 860G001)
www.promelectroavtomat.ru
To Next Page
Loading...
