A = B
(A)
Adjusting Needle Drop Position
When the straight stitch is selected on the touch panel, the needle should be positioned in
the center of the needle plate hole.
When the zigzag stitch is selected with the zigzag width set to the maximum (7.0), the
clearance between the side of the needle and the edge of the hole of the needle plate at the
left and right needle position should be 0.2 mm or more.
1. Remove the top cover and slect stitch No. 1 (straight
stitch).
Lower the needle to its lowest position by turning the
handwheel toward you.
2. Loosen the screw (A).
Move the zigzag rod (1) left or right to set the needle (a)
in the center of the hole of the needle plate (3), then
tighten screw (A).
3. Select stitch No. 8 (zigzag).
Set the zigzag width to the maximum (7.0).
4. Turn the handwheel toward you to check if the clear-
ance between the side of the needle and the edge of the
hole of the needle plate (3), at both left and right needle
positions, is 0.2 mm or more (4).
5. Attach the top cover.
(1)
(a)
(3)
(4)(4)
17
www.promelectroavtomat.ru
To Next Page
Loading...
