52
1. The system will retract all stabilizer jacks and the rear leveling jacks, then extend or
retract the tongue jack until proper connection height is achieved. Display will read
“”. (M below)
2. When the system has completed the “Auto Reconnect” function the display will read
“Auto Reconnect Successful” and a beep will sound. (N below)
1. Press HOME SCREEN. (O below)
2. Press and hold RETRACT (P below) until the unit can be connected to the tow vehicle.
3. Connect the unit to the tow vehicle.
4. Press AUTO MODE. (Q below)
5. Press TONGUE JACK RETRACT. (R below)
1. Press OK (S below) to begin “” or STOP to make a new selection.
The display will read “”.
2. When the jack has been fully retracted the display will read “
” (T below) and a beep will sound.
3. Raise all adjustable feet to the hole that provides the most ground clearance before
towing the unit.
4. Press ON/OFF to deactivate the display.
5. Close and latch the cover of the touch screen display.
Always check to ensure the unit is properly connected to the tow vehicle be-
fore retracting the tongue jack
Always check to ensure the unit is properly connected to the tow vehicle be-
fore retracting the tongue jack
To Next Page
Loading...
Need help?
General
