Programming Guide – 175
Programming the Source Optics Module
The source optics module can be programmed using IEEE 488.2 and SCPI commands. Table
20 lists IEEE commands and Table 21 lists SCPI commands.
Table 20: IEEE 488.2 Common Commands
Command Parameter Response Minimum Maximum
*CLS N/A N/A N/A N/A
*ESE NRf N/A 0 255
*ESE? N/A NRf 0 255
*ESR? N/A NRf 0 255
*IDN? N/A String N/A N/A
*OPC N/A N/A N/A N/A
*OPC? N/A NRf 1 1
*OPT? N/A String N/A N/A
*RST N/A N/A N/A N/A
*SRE NRf N/A 0 255
*SRE? N/A NRf 0 255
*STB? N/A NRf 0 255
*TST? N/A NRf 0 1
*WAI N/A N/A N/A N/A
SCPI Command Tree
All commands, other than the IEEE 488.2 common commands, are listed in Table 21. The
following abbreviations are used in the Command Status column on the computer screen:
• SC (SCPI-confirmed command)
• SA (SCPI-approved command)
• N (command is neither SCPI confirmed nor approved)
Table 21: SCPI SOM Commands
Command Form Parameters Min Max Response
:STATus
:OPERation
:CONDition? NRf
:ENABle NRf
(table continued)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...