Getting Started – 21
Getting Started
The Swept Wavelength System consists of six main components:
• Transmitter, consisting of a source optics module and a tunable laser source
• Transmitter cabinet
• Receiver, with a control module and detector modules
• Parallel port interface or data acquisition board
• Software
• User-supplied computer
Before Initializing and Operating the Equipment
þ Inspect the units for any signs of damage.
þ Read the user’s manual thoroughly, and become familiar with all safety symbols and
instructions to ensure that the units are operated and maintained safely.
Initial Inspection
Warning
To avoid electrical shock, do not initialize or operate any unit if it bears any sign
of damage to any portion of its exterior surface, such as the outer cover or
panels.
Caution
Acclimatize the tunable laser source for one to two hours after removing it
from the shipping carton. Allow an additional hour of warm-up after the unit
has been cycled and left on.
Always use the key to power down the laser. Wait for the laser to park
before switching the power off on the back panel.
After turning off the tunable laser source, wait at least 30 seconds before
powering it on again.
Check that the units and contents are complete:
1. Wear an anti-static wrist strap and work in an electrostatic discharge (ESD) controlled area.
2. Inspect the shipping containers for any indication of excessive shock to the contents, and
inspect the contents to ensure that the shipment is complete.
3. Inspect the units for structural damage that can have occurred during shipping.
4. Ensure that the power switch is set to O (off).
5. Connect each unit to a power source, using the AC power cord provided.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...