180 – Programming Guide
Self-Test Query
Syntax *TST?
Function Initiates a self-test of the source optics module and returns 0, when the source
optics module passes the self-test, or 1, if it fails
During self-testing, established optical paths are interrupted for approximately 10
seconds while the position of the switching mechanism is verified.
Example *TST?
*WAI Command
Syntax *WAI
Function Prevents the source optics module from executing more commands or queries,
until all previously pending operations are complete
There are no consequences to this command because all commands are
executed sequentially; therefore, any subsequent commands are completed by
the time this command is parsed.
Example *WAI
SCPI Status Commands
The following tables describe SCPI status commands.
:STATus:OPERation:CONDition?
Syntax :STATus:OPERation:CONDition?
Function Returns the contents of the operation condition register as an integer that, when
converted to a binary number, represents the bit values of the register
Example :STAT:OPER:COND?
:STATus:OPERation:ENABle
Syntax STATus:OPERation:ENABle <space> <NRf>
Function Sets the bits in the operation enable register. The NRf value is rounded to the
nearest integer and converted to a binary number. The bits of the register are set
to match the bit values of the binary number.
Example :STATUS:OPERATION:ENABLE 33 sets bit 0 and bit 5 of the operation enable
register to 1.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...