Reference – 211
Component Condition Measurement Answer Comment
What is the maximum
power measured at output
port 2?
Source Optics
Module
System
running
Action: Reconnect Signal
Cond. Out.
What is the maximum
power measured at output
port 3?
System
running
Action: Reconnect Signal
Cond. Out.
What is the maximum
power measured at output
port 4?
System
running
Action: Disconnect Signal
Cond. Out.
What is the maximum
power measured at output
port 1?
Receiver
Action: Remove the
connector at the TX IN port
on the CM of the receiver.
Measure power at this
point.
What is the power going to
the CM?
How many receiver chassis
are connected?
Is a compact two-channel
receiver installed?
YES
NO
How many channels does
the receiver have?
Action: Reconnect the
input to the CM.
What is the power going to
the DUT?
Action: Check the
connection to the receiver.
Is the receiver connected
properly to the computer?
YES
NO
SWS
Software
SWS
software
running
Are the LEDs on the
receiver lit up?
YES
NO
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...