6. After the shift is completed and the N (Neutral) light
stays on, release the N (Neutral) button.
7. Shift the transmission into REVERSE or DRIVE.
8. Release the brake pedal for five seconds and
ensure that there is no vehicle movement.
9. Press and hold the brake pedal. Shift the transmis-
sion back into NEUTRAL.
10. Apply the Electric Park Brake.
11. With the transmission and transfer case in N (Neu-
tral), push and hold the ENGINE START/STOP but-
ton until the engine turns off. Ensure vehicle is in
RUN position with the engine off.
12. Place the transmission gear selector in PARK.
Release the brake pedal.
13. Push the ENGINE START/STOP button twice (with-
out pressing the brake pedal), to turn the ignition
to the OFF position.
14. Attach the vehicle to the tow vehicle using a suit-
able tow bar.
15. Release the Electric Park Brake. Ensure vehicle is
in RUN position with the engine off.
16. Turn the ignition to the ON/RUN position, but do
not start the engine.
17. Confirm that the steering column is unlocked.
18. Disconnect the negative battery cable, and secure
it away from the negative battery post.
NOTE:
Disconnecting your vehicle battery will erase radio
presets and may affect other vehicle settings. It may
also trigger various fault codes, causing MIL illumi-
nation when the battery is reconnected.
Shifting Out Of N (Neutral)
Use the following procedure to prepare your vehicle for
normal usage:
1. Bring the vehicle to a complete stop, leaving it con-
nected to the tow vehicle.
2. Apply the Electric Park Brake.
3. Reconnect the negative battery cable.
4. Turn the ignition to the OFF position.
5. Start the engine.
NOTE:
○
Steps 1 through 5 are requirements that must be
met before pushing the N (Neutral) button, and
must continue to be met until the shift has been
completed. If any of these requirements are not
met before pushing the N (Neutral) button or are
no longer met during the shift, the N (Neutral)
indicator light will flash continuously until all
requirements are met or until the N (Neutral)
button is released.
○
The ignition must be in the ON/RUN position for
a shift to take place and for the position indicator
lights to be operable. If the ignition is not in the
ON/RUN position, the shift will not take place
and no position indicator lights will be on or
flashing.
○
A flashing N (Neutral) position indicator light indi-
cates that shift requirements have not been met.
6. Press and hold the brake pedal.
7. Shift the transmission into NEUTRAL.
8. Using a ballpoint pen or similar object, push and
hold the recessed transfer case N (Neutral) button
(located by the selector switch) for two seconds.
9. When the N (Neutral) indicator light turns off,
release the N (Neutral) button. After the N (Neutral)
button has been released, the transfer case will
shift to the position indicated by the selector switch.
N (Neutral) Button
N (Neutral) Button
166 STARTING AND OPERATING
To Next Page
Loading...
