3. Route the shoulder belt to the inside of the right
head restraint.
4. When the seat belt is long enough to fit, insert the
mini-latch plate into the mini-buckle until you hear a
“click.”
5. Sit back in seat. Slide the regular latch plate up the
webbing as far as necessary to allow the seat belt to
go around your lap.
6. When the seat belt is long enough to fit, insert the
latch plate into the buckle until you hear a “click.”
7. Position the lap belt so that it is snug and lies low
across your hips, below your abdomen. To remove
slack in the lap belt portion, pull up on the shoulder
belt. To loosen the lap belt if it is too tight, pull on
the lap belt. A snug seat belt reduces the risk of
sliding under the seat belt in a collision.
8. Position the shoulder belt on your chest so that it is
comfortable and not resting on your neck. The
retractor will withdraw any slack in the seat belt.
9. To release the seat belt, push the red button on the
buckle.
10. To disengage the mini-latch plate from the mini-
buckle for storage, insert the regular latch plate
into the center slot on the mini-buckle. The seat
belt will automatically retract to its stowed position.
If necessary, slide the latch plate down the web-
bing to allow the seat belt to retract fully. Insert the
mini-latch plate and regular latch plate into its
stowed position.
WARNING!
•
If the mini-latch plate and mini-buckle are not
properly connected when the seat belt is used by
an occupant, the seat belt will not be able to pro-
vide proper restraint and will increase the risk of
injury in a collision.
•
When reattaching the mini-latch plate and mini-
buckle, ensure the seat belt webbing is not
twisted. If the webbing is twisted, follow the pre-
ceding procedure to detach the mini-latch plate
and mini-buckle, untwist the webbing, and reat-
tach the mini-latch plate and mini-buckle.
Mini-Latch Plate
Routing The Third Row Seat Belt Latch Plate
Connect Mini-Latch To Mini-Buckle
Third Row Center Seat Belt Buckled
SAFETY 229
6
To Next Page
Loading...
