JetCat RX Series - System Connection Rxi Photo

JetCat RX Series

54 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

PAGE 16 of 54

System Connection RXi Photo

To fueltank

To receiver

Table of Contents

Default Chapter3
- Table of Contents3
Introduction5
Quick Start Section for Rx Turbines with V10 Ecu8
- Identify Components8
Mounting the Turbine Support Equipment (Rx)9
Mounting the Turbine (Rx/Rxi)9
- Turbine Side View / Thrust Tube10
Inlet Protection10
Connections11
- Complete System Connection Diagram Rx11
- Complete System Connections Rx Photo12
- Fuel Connections Rx13
- Hopper Tank - Uat13
- Electrical Connection14
- Interconnections14
- Complete System Connection Diagram Rxi15
- System Connection Rxi Photo16
Power17
Ground Support Unit (Gsu)18
- Gsu Control Panel Descriptions18
- Gsu Switch Descriptions19
The Led I/O Board19
- Description of Leds on the Gsu and Led Board19
Jetcat V10 Ecu20
- Switching on the Ecu20
Single or Two Channel Operation21
- How to Set Your Ecu for Single Channel Operation21
Setup Failsafe Mode21
- Setting the Failsafe21
- Learn R/C". Teach the Ecu to the R/C System23
- Verify Failsafe Programing25
?Learn R/C”. TEACH the ECU to the R/C SYSTEM25
Preparing Fuel and Fuel System25
- Fueling on Board Tanks25
- Prime the Pump and System (Not Needed for the Rxi)26
Running the Turbine for the First Time26
- The Checklist26
- Before Running the Turbine26
- After Stopping the Turbine26
- Starting and Stopping the Turbine27
- After the Start Process Is Initiated, the Following Occurs27
- Automatic Cooling Process27
Gsu (Run Menu Default) Display Symbols28
- Initial Default Display Screen after Power up28
- After Power up - "Error Condition" Display Screen28
- Turbine Starting Display Screen30
- Turbine Running Display Screen30
Turbine Running States30
- Explanation of the Turbine States31
Troubleshooting33
- Most Frequent Errors. Cause and Remedy33
- Reason for an Unexpected Shut-Down34
Manual Advanced Section35
Jetcat Ecu Features Version 10.0035
- Smoker Valve36
Menu Structure40
- Menu Selections40
  - Selecting a Menu40
  - Change Values / Items40
- The Run Menu40
- The Min/Max Menu41
- The R/C Check Menu41
- The Info Menu42
- The Statistic-Menu43
- The Limits Menu43
Airspeed Sensor47
- Special Function53
  - Temperatur Adjustment53
  - Reset to Default Value54

Related product manuals

JetCat RXi Series

Preview: JetCat SPH5

JetCat P550-PRO

JetCat P300-PRO

JetCat P400-PRO

JetCat P1000-PRO

Preview: JetCat PRO Series

JetCat PRO Series