Pump start voltage is adjusted too low:
If the pump start voltage is adjusted too low, the pump may not start to turn (Æ the red
“pump running” LED is illuminated, but the pump is not turning). This can result in the
turbine, after ignition on propane, running an unusual long time and not picking up RPM.
If this time is too long (>10sec.), the ECU will terminate the start and show an Error
message “AccTimOut” or “Acc. Slow” (=acceleration too slow).
Pump start voltage is adjusted too high:
If the pump start voltage is adjusted too high, the turbine maybe supplied with too much
fuel during start up. This could result in heavy flames behind the turbine (Æ turbine
RPM too low compared to fuel being supplied).
21
To Next Page
Loading...
Need help?
General
