Mounting the Turbine
A two-piece, aluminum mounting bracket is included with the turbine. Place the bracket
around the turbine, with the glow plug situated within the slot of the smaller bracket
piece. This will help stabilize the engine along the thrust axis. The glow plug must be in
the vertical position, when mounted in your model (+/- 75° of engine rotation, from the
glow plug at top dead center, is the allowable deviation). Secure the engine, using four
metric mounting screws and lock washers that are provided with brackets.
Connections to the Turbine
To ECU (Glow
plug / starter
motor 3 core lead
To ECU temp and
rpm sensor
Auxiliary gas
(propane/ butane
connection 3mm
pipe to gas valve
Fuel feed. 4mm to fuel pump
24
To Next Page
Loading...
Need help?
General
