AD-1272 Advanced Thermal Dispersion Probe Airflow Measuring System Technical Bulletin
7
Flow Configuration
(Flow Config)
Configures system variables including duct size and shape, elevation, process type, and
process maximum/units.
Display Configuration
(Display Config)
Selects LCD display parameters.
Analog Output 1
Parameters
(Output 1 Param)
Selects Analog Output 1 parameters including temperature, flow, or none.
Analog Output 2
Parameters
(Output 2 Param)
Selects Analog Output 2 parameters including temperature, flow, or none.
Temperature Low Pass
Filter
(Temp LPF)
Selects the amount of filtering applied to the analog output for temperature.
Flow Low Pass Filter
(Flow LPF)
Selects the amount of filtering applied to the analog output for flow.
Analog Output Calibration
(Output Cal Menu)
Adjusts the span for the analog outputs.
Temperature Balance
Menu
(Temp Bal Config)
Selects an offset to apply to the reported average temperature including front panel display,
BACnet®, and Analog Outputs 1 and 2.
K-Factor Configuration
(K-Factor Config)
Turns the K-Factor on and off and allows for the calculation or selection of gain and offset
values.
Menu Inactivity Timeout
(Menu Timeout)
Selects a time period after which the backlight on the front panel display turns off when no
menu activity is detected and automatically returns to normal operation.
BACnet Configuration
(Network Cfg)
Configures BACnet settings and turns BACnet on and off.
BACnet Flow Alarm
Configuration
(Flow Alarm Cfg)
Configures high and low setpoints, deadband, and alarm delay settings and turns the BACnet
flow high and low alarms on and off.
BACnet Temperature
Alarm Configuration
(Temp Alarm Cfg)
Configures high and low setpoints, deadband, and alarm delay settings and turns the BACnet
temperature high and low alarms on and off.
Exit Operator Menu
(Exit Oper Menu)
Returns the display to normal operation.
Table 1: Operator Menu Submenus
Operator Menu
Submenus (Actual
Display Name)
Submenu Description
To Next Page
Loading...