210.100-IOM (JUL 2021)
Page 32
AcuAir Hygienic Air Units
Installation
Table 2: AcuAir single-lter application (non-HEPA lter)
Table 3: Filter, clips, and frames
Table 4: Pre-lter dimensions
Filter holding clips to be used with
filter styles
4 in. pleated panel prefilter 12 in. rigid final filter, double header
style
C86 or CA-04s
a
-
C80 or CF83Fs
-
a
Note:
• Unless specied otherwise, filter dimensions are designated in width x height x depth.
• XL8-HC lters are AcuAir
®
standard supply for prelters.
Description AcuAir part number
Filter holding clips
4 in. galvanized clip KOCH 122 713 003
4 in. stainless clip KOCH 122 712 003
12 in. galvanized clip KOCH 122 713 002
12 in. stainless clip KOCH 122 712 002
Filter holding clips to be used with the smooth filter frames, which require knock-on clips
4 in. SS knock-on clip KOCH 122 705 004
12 in. SS knock-on clip KOCH 122 708 012
Type 8 filter frames (notchless style frames require the knock-on clips above)
12 in. X 24 in. - 16 gauge galvanized KOCH 122 608 1224
12 in. X 24 in. - 18 gauge stainless steel KOCH 122 618 1224
12 in. X 24 in. - 18 gauge SS notchless KOCH 310 123 107
24 in. X 24 in. - 16 gauge galvanized KOCH 122 608 2424
24 in. X 24 in. - 18 gauge stainless steel KOCH 122 618 2424
24 in. X 24 in. - 18 gauge SS notchless KOCH 310 123 106
Width x height x depth (in.)
Filter type AcuAir part number
12 X 24 X 4
MER 8, MP XL8 high capacity
KOCH 102 701 023
24 X 24 X 4 KOCH 102 701 031
12 X 24 X 4
MER 8, MP XL8 high capacity
KOCH 102 500 023
24 X 24 X 4 KOCH 102 500 031
Alternate disposable pleated panel filter
NOTICE
You must install lter pleats vertically when possible.
NOTICE
When filters are supplied by others, usually so are
the filter clips.
Note:
• The 4 in. SS knock-on clip part is stainless steel, not latch wire.
• 12 in. SS knock-on clip total SS construction; product description must follow part number for entry.
To Next Page
Loading...
