Johnson Controls Frick AcuAir - HEPA Filter Application; Non-HEPA Filters in HEPA Frames

210.100-IOM (JUL 2021)
Page 34
AcuAir Hygienic Air Units
Installation
HEPA lter application Non-HEPA lters in HEPA frames
Description AcuAir part number
AcuAir HEPA lter frames
H x W (in.)
-
24 X 24-14 gauge galvanized KOCH 122 508 2424
12 X 24-14 gauge galvanized KOCH 122 508 1224
24 X 24-14 gauge stainless steel KOCH 122 518 2424
12 X 24-14 gauge stainless steel KOCH 122 518 1224
99.97% BioMAX HC HEPA (MERV 17), galvanized
H x W x D (in.) -
23.375 X 23.375 X 11.5 KOCH H64A 2X1
23.375 X 11.375 X 11.5 KOCH H79A 2X1
11.375 X 23.375 X 11.5 KOCH H60A 2X1
99.99% BioMAX HC HEPA (MERV 18), galvanized
H x W x D (in.) -
23.375 X 23.375 X 11.5 KOCH H64A 4X1
23.375 X 11.375 X 11.5 KOCH H79A 4X1
11.375 X 23.375 X 11.5 KOCH H60A 4X1
Width x height x depth (in.) AcuAir part number
MERV 13 Rigid with gasket downstream (DS)
24 X 24 X 12 DH KOCH 110 722 030K
12 X 24 X 12 DH KOCH 110 722 031K
MERV 14 Rigid with gasket downstream (DS)
24 X 24 X 12 DH KOCH 110 720 030K
12 X 24 X 12 DH KOCH 110 720 031K
NOTICE
Non-HEPA lters must be installed with the pleats
oriented vertically whenever possible
NOTICE
HEPA lters must always be installed with the pleats
oriented vertically
High Capacity
BioMax HC
Multi-Cell
SBM 85 or 95
Table 6: HEPA lter application dimensions Table 7: Non-HEPA lter dimensions in HEPA frame
Note:
• Unless specied otherwise, lter dimensions are desig-
nated in width x height x depth.
• SH = singel header, DH = double header
Figure 41: BioMax and SBM lters