Johnson Controls S300 Series - DC Power Source; Chassis Grounding

RDR2S-A and I8O4 Hardware Installation Mounting
24-10239-596 Rev. D
6
Package Contents
Package contents are as follows:
• S300-DIN-RDR2SA or S300-DIN-I8O4 module
• Connectors set
•This manual
Tools Needed
Small, straight-blade screwdriver for securing wires in the terminal
blocks.
M
OUNTING
The RDR2S-A or I8O4 module can be mounted on a flat surface, DIN rail, or
in a Johnson Controls’ approved enclosure (for example: S300-DIN).
For information on mounting the RDR2S-A or I8O4 module in an enclosure,
refer to the manual provided with the enclosure.
DIN Rail Mounting
To mount an RDR2S-A or I8O4 module on a DIN rail:
1. Fully extend the white clips located on the bottom of the module.
2. Hook the module on top of the rail.
3. Push in the clips.
To remove a module from the DIN rail:
1. Pull down the clips at the bottom of the module.
2. Pull the bottom of the module out and lift it up.