Table 24: SNE ordering information
Product code number Description
M4-SNExxxxx-xxx
(base features of each SNE)
SNE Supervisory Network Engine Series
Requires a 24 VAC or 24 VDC power supply. Each model includes one Ethernet
port, one RS-485 communications port, two standard USB serial ports, and one
micro-USB port (future use).
Supported IP integrations: BACnet/IP, BACnet/SC, Modbus TCP/IP, KNX IP, C-
Cure/victor, MQTT, and OPC UA.
Supported field bus integrations: MS/TP (RS-485) FC Bus, N2 Bus, Modbus RTU,
M-Bus, and Zettler
M4-SNE22000-0 (version 1-
discontinued)
M4-SNE22001-0 (version 2)
M4-SNE22002-0 (version 3
Supports two local field bus device integrations with a maximum of 100 devices
on each trunk for a maximum of 200 devices per engine if only using the local
field buses. The engine supports a total of 600 devices across all integrations.
Also includes an RJ-12 connection for the FC Bus. An optional LonWorks adapter
can be connected to USB port to add LON communications. Also supports one
BACnet/IP device integration.
M4-SNE11000-0 (version 1-
discontinued)
M4-SNE11001-0 (version 2)
M4-SNE11002-0 (version 3)
Supports one local field bus device integration with a maximum of 100 devices
on the trunk. An optional LonWorks adapter can be connected to USB port to
add LON communications. Also supports one BACnet/IP device integration.
M4-SNE10500-0 (version 1-
discontinued)
M4-SNE10501-0 (version 2)
M4-SNE10502-0 (version 3)
Supports one local field bus device integration with a maximum of 50 devices on
the trunk. An optional LonWorks adapter can be connected to USB port to add
LON communications. Also supports one BACnet/IP device integration.
M4-SNE110L0-0 (version 1-
discontinued)
M4-SNE110L1-0 (version 2)
M4-SNE110L2-0 (version 3)
Supports one local field bus device integration with a maximum of 100 devices
on the trunk. This model is intended for use with Metasys Server Lite (ADS-Lite-
A) software in select regions of Australia, China, Hong Kong, India, Indonesia,
Japan, Korea, Malaysia, New Zealand, Philippines, Singapore, Taiwan, Thailand,
Vietnam, and select branches.
Note: This model does not support the N2 Bus or LonWorks network inter-
face, but does support one BACnet/IP device integration.
Table 25: Modbus tool training course ordering information
Course number Course title and description
C-10077-EN VGE Tool Software Training (North America)
The VGE tool is required to generate custom Modbus mapping tables.
PTK-CONT-26 VGE Tool Software Training (Europe and Asia)
The VGE tool is required to generate custom Modbus mapping tables.
Note: Modbus Integrations require one or more vendor Modbus definition (VMD) tables for specific third-party
equipment. You can purchase tables from your regional System Integration Services (SIS) office, or you can create
the tables with the VMD Generator Express (VGE) tool. To obtain a license, attend the training listed in this table.
SNE Installation Guide22
To Next Page
Loading...
Need help?
General
