Brecknell
Models: Brecknell CP130
• Dimensions: 2.50 in x 3.75 in. x 5.25 in. (H x W x D)
• Paper: Thermal 57 mm (2.25 in.)
• Type: Dot Matrix
• Purchase: 800-637-0529 (North America), +44 (0) 845-246-6717 (Europe and ME)
• P/N AWT 05-505788 (printer, cable, 1 roll of paper)
• P/N AWT 05-505594 (power supply)
• P/N AWT 05-505671 (case, 20 rolls of paper)
Printer connections
Connect the printer to the Control Center Microboard as follows. Only one printer can be connected
at a time. Modify the cable and connect as shown in the following table.
Table 152: Printer connections
Microboard Printer Function
J2-4 Pin 3 TX Data to the printer
J2-2 Pin 5 Busy signal from the printer
J2-9 Pin 6 Signal Common
Figure 66: Brecknell printer
Control center setup
Chiller ID
Access level required: Operator
Using the Comms screen, assign an identification number to the chiller. This number appears at the
top of each report.
Printer setup
Access level required: Operator
Using the Comms screen, the Control Center must be configured to transmit data in the same
format as the printer is configured to receive the data. The following values must be entered:
• Baud Rate: Set to 9600 for Brecknell 19200 for OKIPOS
• Data Bits: 8
• Parity: None
169YVAM with OptiView Control Center
To Next Page
Loading...
