101
POWERHEAD
THERMOSTAT
6
Breather Plate and Thermostat
Install the reed valve on the cylinder block and
secure with a screw.
Install the gasket and breather plate on the cylin-
der block and secure with the three screws.
Install the thermostat. Refer to THERMOSTAT on
p. 101.
THERMOSTAT
Removal
Remove the recoil starter assembly. Refer to
MANUAL STARTER on p. 139.
Remove the four bolts and thermostat cover.
Remove the thermostat.
Inspection
If salt deposits, corrosion, wear, or other damage
is found, clean or replace the thermostat.
1. Reed valve 006133
1. Breather plate 006134
1
1
1. Thermostat cover
2. Bolt (4)
006137
1. Thermostat 006066
Thermostat 006140
1
2
1
To Next Page