Johnson J2R4SUC 2007 - Tiller Handle

110
MIDSECTION
REMOVAL
REMOVAL
Remove the powerhead. Refer to POWERHEAD
on p. 73.
Remove the gearcase. Refer to GEARCASE on
p. 119.
Remove the water tube with the grommet upside.
Remove the spring pin and the tilt lock wing nut.
Remove the tilt lock spacer.
Remove the swivel shaft nut and swivel shaft
washer.
Remove the port side clamp bracket and tilt fric-
tion washer.
Remove the tilt lock bolt and the thrust block with
the lower thrust mount.
1. Water tube 006146
1. Spring pin
2. Nut
3. Spacer
006147
1
3
2
1
1. Nut
2. Washer
006148
1. Side clamp bracket – port
2. Washer
006149
1. Tilt lock bolt
2. Lower thrust mount
006150
2
1
2
1
1
2