Johnson J2R4SUC 2007 - Maintenance

MAINTENANCE
INSPECTION AND MAINTENANCE SCHEDULE
39
3
Crankcase oil, replace
(2)
H
33
Oil filter, replace
33
Valve tappet clearance, inspect
(3)
33
Engine upper and lower motor covers, clean and wax
3
Starter pinion shaft, inspect and lubricate F
3
Gearcase lubricant, inspect fill level and condition of lube B
3
Propeller shaft, inspect and lubricate D
3
Spark plugs, replace
(3)
3
Decarbonize G
3
Operator’s Guide, review
3
Breather and fuel line, replace
3
Carburetor, inspect
3
Driveshaft splines, inspect and lubricate E
3
Fuel filter, replace
3
Ignition timing, inspect
3
Water pump, inspect and replace
3
(1) Also recommended at 10-Hour Inspection
(2) Replace every 100 hours or annually if Ultra 4-Stroke oil is not used.
(3) Emission-related component
A
Evinrude/Johnson Anti-Corrosion Spray or Evinrude/Johnson “6 in 1” Multi-Purpose Lubricant
B
HPF XR Gearcase Lubricant
C
Power Trim/Tilt and Power Steering Fluid
D
Triple-Guard Grease
E
Evinrude/Johnson Moly Lube
F
Starter Bendix Lube Only
G
Evinrude/Johnson Engine Tuner
H
Evinrude/Johnson Ultra 4-Stroke synthetic blend oil
Engine Maintenance and Inspection Schedule
Description
Engine
Care
Product
Frequency
Each Use 10-Hour Inspection Every 50 Hours or 6 months Every 100 Hours or Annually Every 200 Hours or Biannually