EasyManua.ls Logo

Jonsered FR2312M - Battery; Connecting the Jump Leads

Jonsered FR2312M
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10 – English
4.2 Battery
WARNING!
Measures after contact with acid
External: Rinse with plenty of water.
Internal: Drink plenty of water or milk. Seek
medical attention as quickly as possible.
Eyes: Rinse with plenty of water. Seek medical
attention as quickly as possible.
The battery generates explosive gases.
Sparks, ames and cigarettes must not occur
Starting the engine with a weak battery
If the battery is too weak to start the engine, it should
be recharged. Charge the battery with max 3 Amps
for 4 hours.
When the battery is fully charged, connect the red
cable to the positive terminal (+terminal) of the
battery and the black cable to the negative terminal
(-terminal). Ensure that the red (+) cable is routed
behind the black (-) cable.
If jump leads are used for emergency starting, follow
the procedure below:
4.3 Connecting the jump leads
IMPORTANT INFORMATION
Your rider is equipped with a 12-volt
system with negative ground. The other
vehicle must also have a 12-volt system
with negative ground. Do not use your
product battery to start other vehicles.
Connect each end of the red cable to the
POSITIVE pole (+) on each battery, exercise care
not to short circuit any of the ends against the
chassis.
Connect one end of the black cable to the
NEGATIVE pole (-) on the fully charged battery.
Connect the other end of the black cable to a good
CHASSIS EARTH, away from the fuel tank and the
battery.
To remove cables, reverse order
Remove BLACK cable rst from chassis and then
from the fully charged battery.
Finally the RED cable from both batteries.
Delivery measures

Table of Contents

Related product manuals