24 – English
Repair instructions
2
3
4
5
6
7
6.7 Removing/assembling the
cable pulley
1 Loosen the rear fastening of the steering
cables (1).
2 Remove the screw (2) and the cable pulley (5).
3 Remove the bearing circlip (3) and tap out the
bearing (4).
4 Assemble the cable pulley in reverse order.
Bushing (6) is placed between the frame and the
cable pulley.
Ensure that the cables are properly placed in the
steering cable pulleys (7).
Ensure that the steering wheel is in the center
position when the rear wheels are centered. Re-set
the chain on the steering column's sprocket or adjust
the rear xture (1) for the steering cables as needed.
Hold the cables with e.g. an adjustable wrench so
they do not twist.
After assembly, the cable tensioning must be
checked (see "Checking and Adjusting the Steering
Cables").
To Next Page
Loading...
