Jonsered FR2312M - Page 28

28 – English
Repair instructions
9 Loosen belt 3 (cutting unit drive) from the tension
roller. Then pull it o󰀨 from the center belt pulley,
then from the belt pulley of the articulated
steering.
10 Remove the rear attachments of both steering
cables.
11 Loosen the articulated shaft’s screw from below.
1
32
4
4
6
5
Loosen the two screws (4) using a half-inch
wrench. Loosen the screw (5) behind the mu󰀪er
and the screw (6) holding the exhaust pipe. The
belt guide can now be removed.Jack up the front
IMPORTANT INFORMATION
When assembling, the gasket between the
mu󰀪er and the exhaust pipe must be replaced.
carriage in front of the cable pulley without
squeezing any cables. Jack up the rear carriage
in the rear edge.
12 Use a slide hammer size M8 to loosen the
articulated shaft and the belt pulleys.
13 Separate the front and rear carriages.