13
SX600 MANUAL • CHAPTER 1: Transmitter Controls
To adjust the control stick length, use a 2 mm
Allen wrench to unlock the set screw located
inside the end of the control stick. Turn the set
screw counter-clockwise to loosen it, then turn
the knurled portion of the stick to adjust the
length. Counterclockwise will lengthen the stick
and clockwise will shorten it. After the control
stick(s) has been adjusted to suit your flying
style, tighten the set screw.
CONTROL STICK LENGTH ADJUSTMENT1.4
CHAPTER 1: TRANSMITTER CONTROLS CONTINUED
TRANSMITTER REAR
1.3
Note: Your transmitter has a 5-year lithium
battery to protect your preprogrammed data
against main transmitter battery failure. If
your system reads 0.0V or has an unfamiliar
display (service mode), or your data resets to
the factory defaults, return your transmitter
to Horizon Service Center (see page 28) for a
lithium battery replacement.
BATTERY CONNECTOR
Use caution when disconnecting/removing the
transmitter battery pack. If the connector is not
properly disconnected, damage to the connector
and/or the radio system can result.
CRYSTAL
(Factory installed)
To Next Page
Loading...
