JR SX600 - Function Mode - Servo Reversing; Servo Reversing

24
SX600 MANUAL • CHAPTER 7: Functions (Function Mode)
CHAPTER 7: FUNCTIONS (FUNCTION MODE)
Servo reversing is a very convenient function
used in the setup of a new aircraft. It is used to
change the direction of servo rotation in
relation to the corresponding stick movement.
Servo reversing is available for all channels.
1. Turn on the transmitter.
2. Press the Scroll and Increase buttons up
simultaneously to enter the Function mode.
3. Press the Scroll button until “REV/NORM”
appears on the screen.
4. Press the Channel button until the desired
channel appears on the screen.
5. Press the Increase or Decrease button to
change the servo direction.
6. Press the Scroll button to access the sub-
trim function.
7. To exit, press the Scroll and Increase buttons
up simultaneously.
SERVO REVERSING • FUNCTION MODE
7.1
Accessing the Servo Reversing Function
1 THR: THROTTLE
2 AIL: AILERON
3 ELE: ELEVATOR
4 RUD: RUDDER
5 GER: LANDING GEAR
6 FLP: FLAP (AUX 1)
Press the Increase or
Decrease button to change the
servo direction
Press the Channel button
until the desired channel
appears on the screen.
Press the Scroll button
until “REV/NORM”
appears on the screen.
THR
REV+NORM
CHANNEL
-