JR SX600 - System Functions - Data Reset; Data Reset Procedure

19
SX600 MANUAL • CHAPTER 6: Functions (System Mode)
CHAPTER 6: FUNCTIONS (SYSTEM MODE)
Accessing the Data Reset Function
The data reset function allows you to reset
all the programming in the selected model
(1 through 10) to the factory settings. Before
using the data reset function, it’s important to
enter the model selection function and select
the desired model number (1 through 10) for
which you want to reprogram to the factory
settings. The model selection function is
described in Section 6.2.
1. Press the Scroll and Increase buttons up
simultaneously and hold.
2. Turn on the transmitter to enter the
System mode.
3. Press the Scroll button up until “RST”
appears on the screen.
4. Press the Channel and Increase buttons
simultaneously to reset the data. (To
confirm that the selected model's
programming has been reset, a beep
will sound and the model number will
momentarily disappear from the screen.)
5. Press the Scroll button to access the model
select function.
6. To exit, press the Scroll and Increase
buttons up simultaneously.
DATA RESET • SYSTEM MODE
6.1
Programming Levers
In System Setup mode, press
the Scroll button up until
“RST” appears on
the screen.
Press the Channel button down and
Increase button up simultaneously to
reset the data (a beep will sound).
RST
1
INDICATES DATA RESET FUNCTION
MODEL NUMBER TO RESET
R S T
I