JR SX600 - Input Mode and Functions; Normal Display; Direct Trim Access Display; Mode Types

17
SX600 MANUAL • CHAPTER 5: Input Mode and Functions
When the power switch is turned on, the
screen will read as shown here in the
diagram. This screen is referred to as
the normal display.
CHAPTER 5: INPUT MODE AND FUNCTIONS
NORMAL DISPLAY
5.1
The Direct Trim function of the SX600 can be
accessed through the use of any of the 4 digital
trims levers (throttle, aileron, elevator, or
rudder).
When a trim input is given, the screen will
automatically change to show the trim value for
that particular channel. Once the trim
adjustment has been made, the screen will
automatically return to the previous screen
setting after 2-3 seconds. The maximum trim
value for each channel is +/- 40 in increments
of 2.
DIRECT TRIM ACCESS DISPLAY
5.2
The SX600 features two types of programming
paths. System mode includes programming
functions that are initially adjusted when the
model is first set up, like selecting wing type
or the model, and is seldom accessed after the
initial setup. System modes include:
MODEL RESET
MODEL SELECT
WING TYPE MIXING
V-TAIL MIXING
MODEL NAME
Function mode includes programming that is
more frequently changed, sometimes at the
flying field. Function Modes include:
SERVO REVERSING
DUAL RATES
SUB-TRIM
TRAVEL ADJUST
MODE TYPES
5.3
THROTTLE CUT
5.4
Your SX600 incorporates a special Throttle
Cut button located on the upper right face
of the transmitter. This feature is designed
to immediately override any current throttle
trim position and will immediately return the
throttle servo to the full low position if the
throttle stick is in the low position. This feature
will allow the engine to be automatically
stopped in case of emergency, or in the event
of a crash. When adjusting your throttle
linkage, please check to ensure that when the
Throttle Cut button is pushed, the throttle
servo will move the carburetor barrel to the full
closed position.
Note: In some cases it will be necessary to
adjust the engines barrel stop screw so that
the carburetor can be fully closed. Please
refer to your engine instructions for more
detail.
MODEL NAME
BATTERY VOLTAGE
INDICATES CHANNEL
INDICATES CURRENT
TRIM VALUE (+ OR --)
- 2
AIL
MDI
10.4V