JR SX600 - Quick Start Guide; Digital Trim Settings; Servo Reversing

4
SX600 MANUAL Quick Start
SX600 QUICK START
In this manual you will find in-depth instructions
that detail all the steps and procedures you should
follow in order to program each of the SX600’s
features. For modelers who want to get into the
air fast, we have provided Quick Start. Quick
Start covers the basic programming information
necessary to get you airborne. Later, when you want
to learn more about specific features of the SX600,
turn to the appropriate pages(s) in this manual for
more detailed programming information.
Note: Please charge the system batteries as
indicated in step 4.1 before attempting the
Quick Start setup and again before flying the
model.
Turn on the transmitter and check to ensure
that the aileron, elevator, and rudder trim
valves are set to the 0 (neutral) position.
Next, set the throttle trim valve to the full low
(-40) position by pressing the throttle trim
lever down.
DIGITAL TRIM SETTINGS
1
SERVO REVERSING
2

With the transmitter on, press the Scroll and Increase buttons
upward simultaneously until a beep is heard.

Press the Scroll button (if necessary) until
“REVERSE-NORM” appears on the screen.
A
B

Press the Channel button to select the
channel you want to reverse.
Press the Increase or Decrease button to
reverse the direction of the
channel you selected.
C
T H R
—
T H R
—
T H R
—