1 THR: THROTTLE
2 AIL: AILERON
3 ELE: ELEVATOR
4 RUD: RUDDER
5 GER: LANDING GEAR
6 FLP: FLAP (AUX 1)
THR
0
SB-TRIM
CHANNEL
INDICATES
SUB-TRIM FUNCTION
SUB-TRIM VALUE (±125)
1 THR: THROTTLE
2 AIL: AILERON
3 ELE: ELEVATOR
4 RUD: RUDDER
5 GER: LANDING GEAR
6 FLP: FLAP (AUX 1)
THR
+I00%
TRV ADJ.
CHANNEL
SERVO OPERATING DIRECTION
INDICATES THE TRAVEL
ADJUSTMENT FUNCTION
TRAVEL ADJUSTMENT VALUE
CHAPTER 7: FUNCTIONS (FUNCTION MODE) CONTINUED
Exponential reduces the sensitivity in the
middle portion of the stick movement, while
still allowing full travel at the end of the stick
movement. The end result (travel) remains the
same, although exponential changes the rate
at which it achieves this travel. The adjustable
range is from 0 – 100%. Zero percent (0%) is
linear stick control, meaning the response rate
is equal throughout the stick control. 100% is
full exponential. The larger the exponential
value, the less servo action or sensitivity you
will notice around the neutral setting.
EXPONENTIAL RATE • FUNCTION MODE
7.3
1. Turn on the transmitter.
2. Press the Scroll and Increase buttons
simultaneously to enter the Function mode.
3. Press the Scroll button until “EXP” appears
on the screen.
4. Press the Channel button until the desired
channel appears on the screen. (AI = aileron
or EL = elevator).
5. The number that appears directly to the
right of the selected channel is the switch
position. There are two switch positions, 0
and 1, for each of the channels. A “0” will
appear when the selected dual rate switch
is in the uppermost position and a “1” when
the selected switch is in the lower position.
6. The number in the center of the screen
Exponential Rate indicates the current
rate value for the selected switch position
and channel. Press the Increase or
Decrease button to adjust the dual rate value
(0-100%).
7. After adjusting the value for the 0 switch
position, change to the 1 switch position and
adjust the rates.
8. Press the Channel button to select the other
channel and adjust the Exponential rate
value for both switch positions.
9. To exit, press the Scroll and Increase buttons
simultaneously.
Accessing the Exponential Rate Function
Press the Scroll button
until “EXP” appears on the
screen.
Press the Channel button
until “AI” or “EL” appears
on the screen.
Press the Increase or
Decrease button to adjust the
Exponential rate value.
AIO
0%
FUNCTION NAME
CHANNEL
AI: AILERON
EL: ELEVATOR
EXPONENTIAL RATE VALUE
INDICATES THE DUAL RATE FUNCTION
EXP
26
SX600 MANUAL • CHAPTER 7: Functions (Function Mode)
To Next Page
Loading...
