JR SX600 - Function Mode - Travel Adjustment; Travel Adjustment

CHAPTER 7: FUNCTIONS (FUNCTION MODE) CONTINUED
The amount of servo travel is adjustable for
each direction for each of the 6 channels
individually. The adjustment range is from 0%
to 150%. Travel adjustment is factory set at
100% for all channels. The travel adjustment
value displayed on the screen depends on the
position of the stick or switch (e.g., flap switch,
gear switch). This function is useful either to
maximize control surface travel or to reduce
travel to eliminate servo binding without the
need for mechanical adjustment.
1. Turn on the transmitter.
2. Press the Scroll and Increase buttons up
simultaneously to enter the Function Mode.
3. Press the Scroll button until “TRV ADJ.”
appears on the screen.
4. Press the Channel button until the desired
channel appears on the screen.
5. Move the selected channel stick or switch
in the direction that you want to adjust the
travel. Press the Increase or Decrease button
to achieve the desired travel. Move the stick
in the opposite direction to adjust the travel
in the opposite direction.
6. The same may be done for all channels.
7. Press the Scroll button to access the Servo
Reverse function.
8. To exit, press the Scroll and Increase buttons
up simultaneously.
TRAVEL ADJUSTMENT • FUNCTION MODE
7.4
Accessing the Travel Adjustment Function
Press the Scroll button until
“TRV ADJ.” appears on the
screen.
Press the Channel button
until the desired channel
appears on
the screen.
Press the Increase or
Decrease button to adjust the
travel adjustment value.
28
SX600 MANUAL • CHAPTER 7: Functions (Function Mode)
1 THR: THROTTLE
2 AIL: AILERON
3 ELE: ELEVATOR
4 RUD: RUDDER
5 GER: LANDING GEAR
6 FLP: FLAP (AUX 1)
THR
+100
%
TRV ADJ.
CHANNEL
INDICATES THE TRAVEL
ADJUSTMENT FUNCTION
TRAVEL ADJUSTMENT VALUE
SERVO OPERATING DIRECTION