Need help?Do you have a question about the JR Venture CP and is the answer not in the manual?
Information about the Academy of Model Aeronautics and its benefits.
Suggestions for preparing and organizing parts before assembly.
Lists components needed to complete the helicopter assembly.
Details on the required R/C helicopter engine and muffler.
Lists necessary building materials for assembly.
Lists tools needed for assembly and maintenance.
Lists essential equipment for flying and setup.
Step-by-step guide for attaching the tail boom assembly.
Steps for assembling and installing the tail control rod system.
Attaching the engine mount and cooling fan.
Steps for attaching the clutch assembly to the engine.
Guide for installing the engine into the helicopter frame.
Steps for mounting and connecting the servos.
Guide for installing the gyro, receiver, and battery.
Explanation of conventional one-servo swashplate systems.
Explanation of the 120-degree CCPM system used in the Venture.
Steps to activate CCPM on XP652/XP662 radios.
Steps to activate CCPM on XP8103/XP8103DT radios.
Steps to activate CCPM on JR 10 Series radios.
Importance of setting equal travel values for CCPM servos.
Correct servo reversing is crucial for CCPM synchronization.
Steps for preparing and installing CCPM servo arms.
Using sub-trim to center CCPM servos.
Attaching the CCPM servo linkages to the swashplate.
Procedure to ensure the swashplate is level.
Adjusting pitch-to-aileron mixing with travel adjust.
Connecting the tail control rod to the servo.
Installing the throttle linkage for carburetor control.
Attaching the helicopter body and canopy.
Procedures for balancing main rotor blades.
Modifying the swashplate for increased 3D control.
Installing 3D flybar and paddles for aggressive flight.
Basic and 3D setup data for XP652/XP662 radios.
Basic and 3D setup data for X-378 radios.
Basic and 3D setup data for XP8103 radios.
Adjusting pitch and throttle curves for optimal performance.
Adjusting gyro gain and verifying direction.
Procedure for adjusting main rotor blade tracking.
Step-by-step guide to hover training.
Post-flight care and regular maintenance procedures.
Assembly steps for clutch and tail drive components.
Assembly of main frame, radio bed, and control system parts.
Assembly of rotor head, flybar, swashplate, and blade holders.
Assembly of tail gear case, hub, and pitch control.
Detailed parts list for the main rotor head assembly.
Detailed parts list for the control system assembly.
Detailed parts list for tail case, rotor, and boom assemblies.
To Next Page
General
