JRC JHS-182 - Page 51

5-30
d) SENDING AND SAVING MESSAGES
In case, “FUNCTION” in Message Type Screen (see a), b) Message Type) is TEXT, for sending or
saving messages, follow the instruction below:

1. Select [SAVE], and save the sent message. Then go to Message
Menu Screen. (The data is displayed at TX TRAY.)
2. Select [TX], then save the sent message, sent sentences and
go to Message Menu Screen. (The data is displayed at TX TRAY.)


If [EXIT] is selected, the MESSAGE TYPE SETTINGS Screen
appears.



Or in the case” Function” is CAPA INTERROG, sending/saving messages are displayed.












d) RETURY SETTINGS
When a message is sent with FORMAT is ADDRESSED, the sender is supposed to obtain a
certification message of receiving from the receiver. When such message is not received because of
some reasons, the sender retries to send the certification message. (= Retry)
Setting up Numbers of Retries
Numbers of retries are changeable. (0〜3, default value is three.).


EDITANDTXUTC11:44
BRG:RNG NAME/MMSI
270°:0.18NM
35°:0.29NM
*22°:0.92NM
OCEAN-LINE
QUEEN
ABCDEFG−MARU
HOWAREYOU?

ABCDEFGHIJKLMNOP
QRSTUVWXYZ.0123
456789[]“#$%&’
()?@+-*/^,:;<=>!
[EXIT]
[SAVE]
[TX]
[ALLCLR]

1.FORMAT:ADDRESSED
MMSI:987654322
2.CATEGORY:ROUTINE
3.FUNCTION:
CAPABILITYINTERROGATE
4.CH:AUTO
 [EXIT]
[SAVE]
[TX]


6.NUMBEROFRETRIES：３ 6.NUMBEROFRETRIES：３6.NUMBEROFRETRIES：１
ChangebytheJogDial. Changeto“3”onthecommandoftransponder.
Retry Settings
SENDING AND SAVING MESSAGES