JRC JHS-182 - Page 68

5-47


・ The registered setup can be seen when the Jog Dial is rotated. Only the saved number of
data is displayed.
・ The CHANNEL SETTING display is displayed when the CLR key is pressed on the screen
① and ② states as the cursor is on the numbers.
・ The cursor moves onto [EXIT] in the small window when the item is selected by Jog Dial
from the screen ① and ② states.
・ If [EXIT] is selected, the cursor returns to the state of Screen ②.
・ If [CHECK] is selected, the transponder outputs the command of the contents. (See
5.3.4.3.1.)
・ When the result is NG, the contents are displayed on the last line.（See 5.3.4.3.1）
・ When the result is OK, the setting can be saved after [SAVE] is selected. (See 5.3.4.3.1)
・ If [SAVE] is selected, the transponder outputs the command of the contents. (See 5.3.4.3.2.)
・ If [ERASE] is selected, the selected contents are erased and then the cursor moves onto
[EXIT].
・ If there are any data which are saved after erased data, all of the data put upward.