JRC JHS-182 - Page 67

5-46

When the [LOAD] in the small screen is selected in the Regional Channel Setting Menu, the
preservation list of manual inputs is displayed.
Moreover, the contents of the setting selected from preservation lists can be registered.
Transponder saves a maximum of nine channel management information.
The data applicable to the condition is eliminated when the ship is separated more than 500NM
from the set-up area or when five weeks pass from the saved time.
This is for saving the time to input the same data manually every time.
A maximum of 8 affairs from the newest manual input settings can be reconfirmed and
re-registered.










The screen ① is displayed if the [LOAD] is selected after the cursor is moved into small screen of
the Regional Channel Setting Menu.
Move the cursor onto 1. at ①. “NO DATA” is displayed if there is no data and then the cursor is on
[EXIT] in the small window.
[CHECK], [SAVE], etc. cannot be selected.

REGIONALCH.SETUTC11:44
BRG:RNG NAME/MMSI
270 ° :0.18NM
35
° :0.29NM
*22
° :0.92NM
OCEAN-LINE
QUEEN
ABCDEFG-MARU
1.
CHA:1087NARROW
CHB:2084NARROW
TX/RXMODE:TX/RX,TX/RX
(CHA,CHB)
TXPOWER:LOW
ZONESIZE:4NM
AREA(NE):N15
° 22.33’
E145
° 59.99’
AREA(SW):N14
° 22.33’
E143
° 59.99’

[EXIT][CHECK][SAVE]
[ERASE]

REGIONALCH.SETUTC11:44
BRG:RNG NAME/MMSI
270 ° :0.18NM
35
° :0.29NM
*22
° :0.92NM
OCEAN-LINE
QUEEN
ABCDEFG-MARU
▲
1.CHA:1022NARROW
CHB:2022NARROW
E145°59.99’
7.AREA(SW):N35°02.33’
E145°39.99’
▼
[EXIT][CHECK][SAVE]
[ERASE]

REGIONALCH.SETUTC11:44
BRG:RNG NAME/MMSI
270 ° :0.18NM
35
° :0.29NM
*22
° :0.92NM
OCEAN-LINE
QUEEN
ABCDEFG-MARU
▲
4.CHA:1022NARROW
CHB:2022NARROW
E145°59.99’
AREA(SW):N35°02.33’
E145°39.99’
▼
[EXIT][CHECK][SAVE]
[ERASE]


[EXIT][CHECK][SAVE]
[ERASE]
NGAREA500NMOVER

[EXIT][CHECK][SAVE]
[ERASE]
OK
Select the re-registered
data.
Press the CLR key to
go back to the
CHANNEL
SETTING PAGE
Transponder answers it as NG.
Transponder answers it as OK and
then [SAVE] can work.
Cursor is returned to the state of
② by [EXIT] selection.
Select [CHECK]
1
The cursor moves onto [EXIT] after
selecting the data.
3
4
2