5-36
Setting the position data source (POSN1/POSN2)
・(D)GPS1： Select when using No.1-GPS or No.1-DGPS for the postion sensor.
・(D)GPS2： Select when using No.2-GPS or N0.2-DGPS for the positon sensor.
・LORAN-C： Select when using LORAN-C for the positon sensor.
・GPS Compass：Select when using GPS Compass for the position sensor.
・DR： Estimate an own ship position with the heading, the speed, the SDME,
and so on.
・none： Do not use a secondary position.
・DR-Reset： Use the GPS data of POSN1 as the DR standard position and correct the
error which occurred in DR use. Select DR-Reset and the value when
left-clicking the [OK] button in the [Sensor Connection] dialog box is
applied.
POSN1/POSN2
・Setting with ON/OFF secondary position display.
Display
［Use Local Port］：Recive a sensor data route terminal board.
［Use LAN］： Recive a sensor data route LAN.
Specifies a primary [POSN1] data source.
（(D)GPS1, (D)GPS2, LORAN-C, GPS Compass and DR）
［Use Local Port］：Recive a sensor data route terminal board.
［Use LAN］： Recive a sensor data route LAN.
Specifies a secondry [POSN2] data source.
（(D)GPS1, (D) GPS2, LORAN-C, GPS Compass, DR, DR-Reset and
none）
To Next Page
Loading...
