14-63 Section 14 Creating a User Chart/ Updating a Chart Manually
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
3 Click on the position of the ending point with the cursor.
An ending point is created and the property information in the object property dialog box is
updated.
4 Adjust the parameters on the object property dialog box.
• Specifying an angle of a clearing line: Display a numeric value input keyboard by clicking
on the [Bearing] input box and enter an angle (0 to 359°).
• Specifying a length of a clearing line: Display a numeric value input keyboard by clicking
on the [Display length] input box and enter a length (0 to 999.99).
• Selecting Not Less Than (NLT)/Not More Than (NMT): Set Not Less Than (NLT) or Not
More Than (NMT) to On by clicking on the button.
When Not Less Than (NLT) is selected, "NLTxx" is displayed for the clearing line, indicating
that the line must not be below "xx". When Not More Than (NMT) is selected, "NMT xx" is
displayed for the clearing line, indicating that the line must not exceed "xx".
For the method of using the numeric value input keyboard, refer to "3.16.2 Name and function
of each section of the keyboard".
5 To create an object on another position continuously, repeat Steps 2 to 4.
Ending
point
Select Not Less Than (NLT)/Not More Than
(NMT).
Latitude and longitude of the starting point
Specify the length of the clearing line.
To Next Page
Loading...
