Section 14 Creating a User Chart/ Updating a Chart Manually 14-64
Creating position coordinates of the starting point
1 Click on the [Enter POSN] button on the drawing toolbar.
The [Enter Position] dialog box appears (Refer to "14.2.6 Creating an object by specifying
latitude and longitude").
2 Enter the coordinates of a starting point and click on the [Enter] button.
3 To create an object on another position continuously, repeat Steps 1 and 2.
Drawing an object with EBL/VRM operation
1 Click on the [EBL/VRM] button on the drawing toolbar.
The cursor changes to the EBL/VRM reference point cursor. (Refer to "14.2.5 Creating an
object in the EBL/VRM mode").
2 Click on the position of the reference point of the EBL/VRM marker.
The EBL/VRM marker is displayed.
3 Place the EBL/VRM marker on the starting point position and click the button.
A starting point is created on the position on which the button was clicked and the property
information is reflected in the object property dialog box. (Refer to "14.2.8 Object property
dialog box").
4 Place the EBL/VRM marker on the ending point position and click the button.
An ending point is created on the position on which the button was clicked and the property
information is reflected in the object property dialog box. (Refer to "14.2.8 Object property
dialog box").
5 To create an object on another position continuously, repeat Steps 2 to 4.
Click
Ending point
Starting point
To Next Page
Loading...
