Section 8 Functions of the ECDIS (Option) 8-38
8.10.1.2 Multi view operation procedure
[Operation When Manipulating Multi View]
• The same view is displayed in View1 and View2.
• Except for the items that can be set up separately in View2, View1 and View2 are displayed by
linking.
• Rubber bands during create or edit operation (such as Route Planning) can only be displayed in
active view.
• EBL/VRM and EBL maneuvers are shared between View1 and View2 and the same contents are
displayed (however, the contents may differ depending on the setting of the measurement
reference point.).
Note
The bearing mode of View2 operates by interlocking with the bearing mode of View1.
[Specifying an area to be displayed in View2]
In View1, you can specify an area you want to display in View2.
1 Click on the [Select Area from View1 for View2] button in the [Multi View Mode] dialog.
The button is displayed in reverse video.
2 Move the cursor to View1.
The cursor changes to the range selection cursor.
To Next Page
Loading...
